JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.


You are watching: How to bleed clutch on ford ranger

*

YouTube - Ford Ranger & Mazda B-Series Pickup Clutch Hydraulic Release device Bleeding Procedures
Your vehicle is favor your wife.Spend some money on them when in a while and they won"t nag you to death.Their Sacrifice....Our Freedom
*
Reactions:steve and also electro
*

*

2005 Ford Thunderbird2004 sport Trac2008 Honda GoldwingFord understand Tech v 40 year in the business
*

Mark V1998 Windstar GL (New Axle)1998 Explorer2003 Mustang Cobra ConvertibleRockAuto Forum Discount http://www.aramuseum.org/threads/rockauto-com-forum-discount.10236/Forum facebook pagehttps://www.facebook.com/aramuseum.org
In the truck, bleed it prefer you would brakes through a helper. I was having difficulties with clutch slipping/engaging slowly, bled the system, acquired a the majority of gunky looking stuff out, haven"t had a problem sense.Bill


See more: Does Joker Know Bruce Wayne Is Batman Is? Did Joker Know Bruce Wayne Was Batman

The video clip is an excellent explaining the process and for new installations. But what if you have to bleed one that is already on the truck.Bleeding the slave is straigh forward as displayed in the video.Bleeding the master cylinder is a challenge as wait bubbles obtain trapped in it. These air bubbles cannot be bled out uneven you either tilt her truck up at around a 45 deg angle (very an overwhelming and dangerous) or pull the end the clutch master and also tilt the up. Ns did the 2nd option. Here"s just how to perform it.1. Unbolt the clutch reservoir, and also feed that thru favor you might be replacing it and its hose. You want to get the clutch reservoir right into a position that will keep the hoses straight and as high over everything else -- bubbles tend to rise.2. Disconnect the starter disconnect move from the clutch master. Disconnect the finish of the clutch push rod native pedal (you won"t have to remove the from the master). Unhook the understand to servant hose from the human body if vital (mine was tied come the frame/body at one or 2 points) -- you don"t need to disconnect that from the slave.3. Twist the end the grasp from the pedal frame assembly (90deg turn). Traction the master and grommet loose from the van firewall. Every little thing will be loose at this point.You"re practically there.4. With a helper stop the reservoir up (so the it doesn"t flop over and also drain out) gently occupational the understand out that the firewall. The master, the grommet, and the rod will come out together. Be certain not to traction too tough on the hose, and also disconnect or relocate anything that might be holding it come the body.5. Once you"re done v #4 you"ll basically have the reservoir in ~ the high allude (in her helpers hand), the master next, and the servant at the bottom, all associated with their corresponding hoses. The looks a little like the video. These room the actions you could take come replace everything anyway but here us are just bleeding it.6. As quickly as friend tilt the grasp cylinder bottom (it is typically pointing increase at around 45deg) you should have the ability to see a couple of bubbles in the reservoir. You can shot to push on the clutch rod and tap on the lines as shown in the video to remove any other bubbles. 7. You"re done. Environment is in reverse. Be sure to save the reservoir together high and also as level as possible, girlfriend don"t desire bubbles getting earlier into the lines. I operated the master and also reservoir into their respective areas at about the exact same time. Make certain the hoses acquire clamped come the body and also that nothing it s okay kinked. You can inspect bleed the servant again as displayed in the video clip if friend want. Refill the reservoir together necessary.Hope this helps.